Canopy Factory 25757 Інструкція з монтажу - Сторінка 3

Переглянути онлайн або завантажити pdf Інструкція з монтажу для Намет Canopy Factory 25757. Canopy Factory 25757 4 сторінки. All-purpose canopy

Друкувати сторінку

Diagram F

#13002

#13004

Diagram G

Working from the inside of the cover, you can hide the bungee

balls from the outside, giving the canopy a cleaner look.

Diagram H

COVER

Cover S-Hooks are

designed to hold the

front & back of the cover

tightly in place.

1. Hook one onto each

of the INSIDE of the

cover legs.

2. Adjust the drawstring

evenly on each side of

the canopy by pulling

the drawstrings on each

end of the cover at the

Twist

same time

tube

3. Secure rope to "S" Hook

4. The next step will

feature our new "TwistTight"

procedure to fit the cover

snugly.

Diagram J

Diagram I

T wistTight

1. To get your cover to fit

snugly over the frame, "twist"

each corner leg pole equally

until the cover becomes very

tight. (diagram A). Make sure to

line up the hole in the top of the

leg with the hole in the corner

side bends.

2. To keep the leg in place,

wrap the bungee cord around

the cross rail, insert "S" Hook

into lined up hole of leg pole

and 3-way connector. This

Twist

will prevent the leg from

"untwisting". Do this for each

tube

corner.

3. Now you are ready to

"BUNGEE" the cover to the

rafter poles. Keep bungee ball

on the inside of the unit for a

cleaner look.

Twist tube this direction

to tighten cover

Step 6

ATTACHING LEGS

For this step you will use the

six leg poles you put together

in step 1.

First you will use part #13002

with the pre-drilled hole at the

top, insert the center leg on

one side, and then do the same

for the corner legs. Repeat this

procedure for the other side.

Now you can secure the legs

to the side bend connectors

with push buttons. Insert the

leg extensions onto the bottom

of the legs.

(See Diagram F)

Step 7

SECURING CO VER

Insert the cord of the bungee-

ball through the grommet, around

the eaves, and then the ball.

When all 4 corners are secured,

work from side to side to get an

even fit. If bungee cords are too

loose, you can double wrap them

around the eaves.

(See Diagram G, H, & I)

WARNING!

USE CAUTION WHEN

ATTACHING BUNGEE CORDS,

THEY CAN SNAP OUT OF

YOUR GRIP AND MAY CAUSE

INJURY.

Step 8

BASE FEET

Insert the Base Feet Plates onto

the bottom of the legs.

(

)

See Diagram J

Manufacturer's Suggestion:

When you take your unit down for the

season, we recommend leaving the poles

assembled so that the next time you put

up the unit it will be easier to construct.

05-25757

11/28/03

Pg.3