Canor TP101 MKII Посібник користувача - Сторінка 2

Переглянути онлайн або завантажити pdf Посібник користувача для Підсилювач Canor TP101 MKII. Canor TP101 MKII 3 сторінки.

11. Power cord - it is necessary to pay particular attention to a power cord, it must be

positioned so as to avoid stepping on it and to ensure it is protected against mechanical

damage.

12. The longer the period during which you do not use the amplifier – you should disconnect

the power cord from the mains supply, or at least turn off the main power switch located on

the rear panel.

13. Subjects containing liquid - do not place these objects (vases, flower pots), so that they

can fall on the amplifier, possibly a fluid could leak out of them on the amplifier.

14. Damage requiring service - equipment should be repaired only to qualified service once:

a) power cord is damaged

b) the device fell into the water or was poured

c) the device was exposed to rain

d) the device works incorrectly

e) the device fell to the ground or is otherwise mechanically damaged.

15. Repairs - all repairs must be entrusted to qualified service.

16. General warning - use the device only in accordance with the instructions.

Caution! To help you avoid an electric shock, do not expose the amplifier to

rain or moisture

Connecting the speakers and signal cables

Input connectors are located at the rear of the amplifier and correspond to the position of the

selector switch on the front of the unit.

All inputs use RCA connectors and are connected by the usual rules, thus right channel- RED,

left channel-WHITE. On the output RCA connectors labeled TAPE OUT, you can connect the

recording equipment, for instance tape recorder, MiniDisc, etc.

The CANOR TP101 MKII does not have input suitable for turntable pickup, it is necessary to

use a separate phono preamplifier, for example CANOR TP 305, which is then connected

between the turntable and a free line level input of the amplifier. For further information

contact your dealer please.

Speaker outputs are made up of two pairs of gold-plated speaker terminals labeled + and – at

the rear of the amplifier.

Ensure that polarity is observed and matches the speakers.

Caution! Make all connections only if the device is disconnected from the

mains

Switching on

If you have already connected all signal sources and speakers, connect the amplifier to the

mains. Please ensure the position of the volume control is fully counterclockwise (zero

volume).

Turn the amplifier on with power switch located at the front of the unit.

Operate the input source and increase the volume control in a clockwise direction until an

audio signal is observed and you hear the sound from the speakers. If for any reason no output

is observed, please refer to the trouble-shooting guide.