cantaloupe ePort Engage Combo Посібник з монтажу - Сторінка 10

Переглянути онлайн або завантажити pdf Посібник з монтажу для Зчитувач карток cantaloupe ePort Engage Combo. cantaloupe ePort Engage Combo 17 сторінок.

Друкувати сторінку

EPORT ENGAGE COMBO

INSTALLATION

Section 02

ePort Engage Combo Installation

INSTALLING THE EPORT ENGAGE COMBO DEVICE

1. It is time to set up the antenna. It should be mounted on top of the vending equipment, so

be sure not to drill into anything that is already on top of the machine or that which could

cause clearance issues.

2. Once you have the surface on top selected, drill a 1/2" hole on top leading into the

vending equipment.

3. Feed the antenna wiring through the 1/2" hole and fasten the nut tightly to the shaft of the

antenna to hold it firmly in place (see figure 2.3).

Note: The nut that comes with the installation kit has a slot on it to make it

easy to slide into place before firmly securing it to the antenna.

Locate 4 11/32'' nuts that secure the bill validator to the vending machine. Remove

these nuts and remove bill validator from machine.

5. With Bill Validator facing you remove the four screws that secure the mask to the

validator.

6. Take the Engage Combo Unit and install the Antenna connection first followed by

MDB and then DEX.

7. Once all connections are secure, place two wires to the left and two wires to the right.

8. Take the bill validator and place over the Engage Unit. Make sure that no wires are

pinched between the Combo and the Bill Validator.

9. Rotate Combo and Validator in your hand and reinstall the 4 screws removed earlier.

10. Reinstall Bill Validator and secure the four nuts removed earlier.

figure 2.3

PAGE

figure 2.4