Akytec ITP11-R-W Посібник

Переглянути онлайн або завантажити pdf Посібник для Вимірювальні прилади Akytec ITP11-R-W. Akytec ITP11-R-W 2 сторінки.

Друкувати сторінку

Ordering code

Display colour:

R - red

G - green

Enclosure type:

W - universal mounting

Specifications

Supply current

Voltage drop

Input signal

Measuring range

Accuracy

Sampling rate (without damping)

Ambient temperature

Application class according to IEC 61140

IP Code

Dimensions (without carrier and cable gland)

Weight

Mounting

Cable clamping range

►

ower supply must be provided not only for ITP11, but also for a sensor. The device voltage drop of 10 V has to be taken into

NOTICE

account.

ITP11-W_0217_EN

Functions

The ITP11 is a universally applicable digital display unit. It is designed to be connected to any device

with a 4-20 mA output (current loop).

The device has the following functions:

–

Process value is displayed in accordance with the set limit values and the decimal point position

–

Display range -999...9999

–

Filter for damping the signal fluctuations with an adjustable time constant

–

Switching between linear and square root (for special transmitters)

–

Displaying error message when exceeding the measuring limit

–

Protection against unauthorized access

Fig. 1

Fig. 2

ITP11-W

Installation

Remove the slide covers (1) in the direction of the arrows (Fig. 2).

Unscrew the screws (3) and remove the front panel (2).

Screw the cable glands (included) with the sealing rings (5) tightly into

the enclosure, so as to guarantee the IP65 protection.

Not used cable entry has to be locked with the blind cap (included).

Feed the cable through the cable gland into the enclosure.

Connect the wire ends according to the wiring diagrams (Fig. 4 - 6)

and tighten the cap nut (6).

Put the front panel (2) back and fasten it with the screws (3).

To mount the device on DIN rail attach the carrier (7) to the device

using the two screws (4) and snap the device onto the DIN rail.

To mount the device on a tube attach the carrier (7) to the tube using

two 6 mm wide cable ties (Fig. 3), then attach the device to the carrier

(7) using the screws (4).

10. To mount the device on the wall use the two holes for the screws (4)

11. Snap the two slide covers (1) onto the front panel (2).

akYtec GmbH · Vahrenwalder Str. 269 A · 30179 Hannover · Germany

from current loop

≤ 10 V *

4-20 mA

3.8...22.5 mA

0.2% + 1 digit

1 reading / s

-40...+80 °C

III

IP65

70 x 50 x 28 mm

approx. 150 g

DIN rail, wall, tube

Ø 3...6 mm

Fig. 3

Tel.: +49 (0) 511 16 59 672-0 ·