Advance Appliances ETS 160 Посібник з встановлення та експлуатації - Сторінка 3
Переглянути онлайн або завантажити pdf Посібник з встановлення та експлуатації для Водонагрівач Advance Appliances ETS 160. Advance Appliances ETS 160 8 сторінок. Advance electric thermal store
Друкувати сторінку
947219 ADVANCE APPLIANCES 8pp A5_Layout 1 10/11/2015 14:41 Page 3
INTRODUCTION
Advance Electric Thermal Store Systems are perfect for installations where
oil or gas is not available or preferred such as rural dwellings or modern
apartments.
No flues are required and the unit is quiet in operation.
Off peak tariffs can be utilised and all units are fitted with two 3kW immersion
heaters. The unit is designed to make use of off-peak tariffs. The top heater
is for top-up during peak tariff times. If only one immersion heater is used
for single tariff or low load preferences, please connect only the bottom
heater. This is a hot water only thermal store.
Mains pressure hot water is provided safely at 20 litres per minute provided
an adequate service is connected to the unit. This enables power showering
without a pump and fast bath filling.
The unit can be fitted and left isolated from the filling point if it is not
possible to fit an overflow.
The blending valve can be orientated to right or left hand hot water service.
Loosen the compression nuts, move valve and re-tighten the nuts.
SITING
The unit can be positioned anywhere within the property, even below hot
water outlets, on a flat even surface.
Do not site in aggressive environments or areas subject to frost.
Please note that the unit must be installed in a position where it can be
serviced and maintained in the future. 200mm top access should be allowed
for. Please also take into account the weight of the unit when full and
ensure that the floor can take the load.
PERFORMANCE
160 litre unit for single standard bath and shower up to 20 litres/minute
Meets HWA specification and current Building Regulations