Dot Origin VTAP100-USB Посібник з монтажу - Сторінка 9
Переглянути онлайн або завантажити pdf Посібник з монтажу для Мережеве обладнання Dot Origin VTAP100-USB. Dot Origin VTAP100-USB 14 сторінок.
Друкувати сторінку
'ATCA' - the serial number for your VTAP100 unit.
l
'Firmware' - the VTAP100 firmware version in use.
l
'KeySlots used:' - a useful check that you have uploaded the necessary key files, since these are
l
deleted when they are uploaded. These two examples show how to read this information:
'KeySlots used:------' shows that no keys have been uploaded.
o
'KeySlots used: 12-4--' shows that key files 1, 2 and 4 have been successfully uploaded.
o
'Boot time' - is the internal clock time since the last unit reboot command. If power was removed
l
to achieve a reboot, the boot time defaults to 1970/00/00 00:00:00.
'VCP enabled' - indicates that the virtual COM port has been enabled.
l
'Status' - should be 0 if operating normally, anything else indicates an error state.
l
VTAP100-USB INSTALLATION GUIDE
PAGE 5