Dahle 846 Інструкція зі встановлення леза

Переглянути онлайн або завантажити pdf Інструкція зі встановлення леза для Різаки для паперу Dahle 846. Dahle 846 2 сторінки. Ream cutter
Також для Dahle 846: Інструкція з експлуатації Посібник з експлуатації (14 сторінок)

Blade Installation Instructions for the DAHLE 842, 846, and 848 Ream Cutter

Blade installation is the opposite of blade removal.

1. Insert the blade carrying device into the new blade with the

bevel side up.

Remove the protective cover from the

blade.

2. Carry the blade with both hands being careful to keep

fingers clear.

3. Insert the blade into the cutter and slide up into place. If

you are having trouble lining up the hex screw holes, try

loosing the blade carrying device from the blade. You can

also pull down on the cutting arm until the screw holes line

up. Be careful to keep your fingers clear of the blade.

4. Tighten the hex screws located on each end of the blade.

Remove the blade carrying device and insert the last of the

three hex screw that holds the blade in place.

5. Raise the cutting arm to its highest position and install the

blue metal blade cover. Insert the two 4 mm hex screw

that holds the cover in place.

6. Place the clear plastic safety cover over the metal arms

and use four 3 mm hex screws to secure the cover in

place.

7. Replace the remaining clear plastic cover on the cutter and

secure with 3 mm hex screws.

8. Insert test paper and make a trial cut.

*After repeated cutting it may be necessary to rotate your

plastic cutting block 90 degrees.

**After repeated sharpening of your blade, it may be

necessary to install the metal spacer provided, to the cutting

arm.

842

846

North America, Inc.

375 Jaffrey Road

Peterborough, NH 03458

(800) 243-8145

www.dahleusa.com

848