Electra Light Beam 300 Посібник користувача - Сторінка 7

Переглянути онлайн або завантажити pdf Посібник користувача для Освітлювальне обладнання Electra Light Beam 300. Electra Light Beam 300 20 сторінок. 12ch
Також для Electra Light Beam 300: Посібник користувача (10 сторінок)

Друкувати сторінку

USER MANUAL - BEAM 300 / BEAM 700

-Please notice that the lamp is not a hot-restrict type, and wait approximately 15 minutes after

having turned off the lamp before you can turn it back on again.

-Make sure switch off before installation or replace the lamp. Never touch it by bare hands when

installing or replacing. Please use a Philips MSD GOLD 300/2 Mini FastFit or Philips MSR GOLD

300/2 Mini Fastfit, replacing it use same type too.

-Unscrew Screw marked A on the back of lamp-holder, it used to remove the lamp panel to

replace the lamp. It is can reach an excellent effects to fine-tuning screw on the back of lamp panel

mark X, Y and Z, which used for adjust to the lamp.

Notice!

Connect one signal input with one signal output.

This fixture is equipped with 3-Pin XLR Sockets for DMX Input and output. Re 3 Pin DMX in & out XLR

Socket, Pin 1 refers to Ground, Pin 2: Signal-, Pin 3: Signal + (as Graphs below):

DMXOutput

-The signal sockets are wired in parallel: one input, one output.

Mounting the device

-DMX512 always used STP (shielded twisted pair). Please advice use big cable or install DMX

distributor during long distance use standard cable.

-Do not separate one DMX Output into two Outputs.

-Do not connect overloaded. The max connected BEAM300 in each DMX Chain is 32 pcs.

-There should be a terminator on the last unit of DMX line. A terminator is a 120 ohm 1 watt resistor

which is a connection between Pin 2 and Pin 3 of a Male XLR connector . Using a cable terminator

will decrease the possibility of erratic behavior .

DMX512 Connection

-Please connect 3-pin XLR connector to 3 Pin socket for DMX IN

-And DMX OUT of former fixtures connects to DMX IN of the next fixture in the DMX Chain with the

same compatible DMX Cable in the DMX-output of the fixture.

Installing or replacing the lamp

CAUTION!

Be careful with your operations. With a dangerous

voltage will suffer burn, caused fire!

Connection of Fixtures

DMXInput