Electra Light LED WASH PRO 3W Посібник користувача - Сторінка 8

Переглянути онлайн або завантажити pdf Посібник користувача для Ді-джейське обладнання Electra Light LED WASH PRO 3W. Electra Light LED WASH PRO 3W 9 сторінок.

Друкувати сторінку

USER MANUAL – LED WASH PRO RGB

In build-in programs 6-13, build-in program 1-4 is to set Strobe. 1 refers to

non-strobe; Strobe speed of 2, 3, 4 is 0.3s/sec, 1s/sec, 5s/sec respectively.

7. Custom-defined White Balance

In Mode 1, set the first channel to 255, through controller to adjust 2, 3,4

channel value, the other channels is 0, When it achieves the expected value,

press Button 【ENTER】 . When there appears "W" before the temperature value

on the LCD display interface, the white balance is set successfully.

If all the user-defined white balance RGB values are set to 0, the white balance

will resume to default value.

8. Master-slave setting

Under master-slave mode, only need to set 1 "HOST", the other lights will be DMX

mode(no need to adjust ID code), only 1"HOST" in entire communication system.

prohibited to connect controller.

IV. Connection of Fixture

1. 3-Pin XLR Socket connection line: 1 pin: signal GND, 2 pin Signal－, 3 pin signal

＋，as listed in the graph below.

2. DMX line should use STP (Shielded Twisted Pair). The transfer distance should be

within the range of 300m. If out of this range, it should be equipped with a DMX

distributor. Each distributor can connect up to 32 fixtures.

3. The DMX line should be connected in series one by one. That is each output of

former fixture connects to the input of its follower, and each output DMX line can

not be divided into more than one outputs;

4. There should be a terminator on the last unit of DMX line. A terminator is a 120

ohm 1 watt resistor which is a connection between Pin 2 and Pin 3 of a Male XLR

connector. Using a cable terminator will decrease the possibility of erratic

behavior.

V. Notice

1. before install or use of this fixture, please read and follow these instructions

carefully and keep this manual in a safe place for future reference;

2. before install or use of this fixture, please check the address code and operating

modes are set right;

3. before install or maintain this fixture, make sure the power is off;

4. When the fixture is running, don't unplug live DMX connection line;

DMX IN

DMX OUT

1 PIN GND

2 PIN SIGNAL－