Advance Tabco GZ Series Інструкція з монтажу - Сторінка 2

Переглянути онлайн або завантажити pdf Інструкція з монтажу для Робочий стіл Advance Tabco GZ Series. Advance Tabco GZ Series 2 сторінки. Drawers

Друкувати сторінку

NS Series Drawers

Contents:

Tools Required:

(1) Outer Drawer Body

(2) 7/16 open end wrenches

(1) Inner Drawer Liner

(1) Drawer Pan Insert

(2) NSF Drawer Slide

(4) 1/4 - 20 x 1/2" Bolts with Nuts

Step 1:

Remove drawer Pan insert. Remove inner Liner. Remove NSF

drawer slide. (Illustration 1)

Illustration 1

Step 2:

Mount outer drawer body

to underside of table using

1/4 - 20 x 1/2" bolts and

nuts provided. NOTE:

Outer drawer body mounts

between drawer angles

(Illustration 2) NOTE: For

30" & wider worktables,

Illustration 2

align front mounting hole of

outer drawer body with slotted hole located 5" off roll edge.

Step 3:

Install NSF drawer slides as shown in Illustration 3.

Step 4:

Extend drawer slide out towards front of table and install inner

drawer body by aligning bearing with notch in drawer slide.

(Illustration 4)

Illustration 3

Illustration 4

Illustration 5

Step 5:

Extend inner drawer body towards front

of table and install drawer insert.

(Illustration 5)

SS & GZ Series Drawers

Contents:

Tools Required:

(1) Drawer Body

(2) 7/16 open end wrenches

(2) Drawer Slides

(4) 1/4 - 20 x 1/2" Bolts with Nuts

Step 1:

Install roller bearing slides to underside of table using

1/4 - 20 x 1/2" bolt and nuts provided. NOTE: Drawer slide

must be positioned to inside of drawer angle. Alignment pin

must be positioned towards front of table (Illustration 1)

Illustration 1

Step 2:

Fully extend drawer slides towards front of table and remove rubber

sleeves from alignment pins. (Illustration 2)

Illustration 2

Step 3:

Position drawer body between drawer slides. Locate holes in

drawer body onto alignment pin. Install rubber sleeves onto

alignment pins. (Illustration 3)

Illustration 3

FS & FG Series Drawers

Contents:

Tools Required:

(1) Drawer Body

(2) 7/16 open end wrenches

(2) Friction Drawer Slides

(4) 1/4 - 20 1/2" Bolts with Nuts

(1) Drawer Retainer Clip

Step 1:

Install friction slides underneath table top using 1/4 - 20 x 1/2"

bolts and nuts provided. NOTE: Drawer slide must be positioned

to inside of drawer angles. (Illustration 1)

Illustration 1

Step 2:

Attach drawer retainer clip loosley to front hole of left drawer slide.

(Illustration 2)

Illustration 2

Step 3:

Pivot retainer clip up while pushing drawer body into slide.

Reposition clip as shown and tighten bolt. (Illustration 3)

Illustration 3