Doug Fleenor Design NODE1-P Посібник користувача - Сторінка 5
Переглянути онлайн або завантажити pdf Посібник користувача для Обладнання для запису Doug Fleenor Design NODE1-P. Doug Fleenor Design NODE1-P 10 сторінок. Single port node ethernet to dmx interface
Друкувати сторінку
Using a web browser to configure the N
The N
1 has a built-in web server that allows remote configuration of a unit across the network. It
ODE
allows for configuration of all aspects of the N
settings, and port options available for the current network protocol.
To access the web server, the computer to be used must be physically connected to the same
network as the N
ODE
IP address, and have a web browser installed.
To start the web server, open a web browser (Internet Explorer, Mozilla Firefox, Google Chrome,
Safari, etc....).
Type the IP address of the N
press Enter on the computer keyboard. The Status Page from the N
Since the N
1 has no display, determining the IP address and configuration of a device can be a
ODE
challenge. The N
ODE
and the subnet mask set to 255.0.0.0.
Before deploying the N
isolated network for configuration. This will allow configuration while the computer and the N
are in close proximity to one another.
If DHCP is enabled in the test network, the N
address has been given to the N
a utility program can be used to locate all Doug Fleenor Design Ethernet nodes on the network. The
node discovery program can be downloaded at:
http://www.dfd.com/NodeDisc.html
If no DHCP server is present, the N
the back of the device. However, if the default IP address has been overwritten by previous
configuration attempts, the N
To set the N
1 to its default configuration settings (including the IP address):
ODE
–
Remove power from the N
–
Remove jumper JP1 (near the Ethernet connector)
Re-apply power, wait about 10 seconds
–
–
Remove power from the N
–
Re-install jumper JP1
–
Re-apply power
The N
1 will now have DHCP enabled and the IP address will be the default as shown on the label
ODE
on the back of the unit.
1. It must be in the same Subnet, have the same Subnet Mask, have a unique
1 in the address bar of the browser. After the address has entered,
ODE
1 is shipped with DHCP enabled, a default IP address in the range of 10.X.X.X,
1 into the field, it is recommended that each N
ODE
1, the DHCP server's client table can be referenced. Alternately,
ODE
1 will use its default IP address which is printed on a label on
ODE
1 will use the user-created address.
ODE
1
ODE
1
ODE
1
ODE
1 including the name, unit description, network
ODE
1 will be assigned an address. To determine what
ODE
5 of 10
1 will be displayed.
ODE
1 is connected to an
ODE
1
ODE