Advance Tabco 7-PS-104 Інструкції з встановлення та усунення несправностей - Сторінка 3
Переглянути онлайн або завантажити pdf Інструкції з встановлення та усунення несправностей для Диспенсер Advance Tabco 7-PS-104. Advance Tabco 7-PS-104 4 сторінки. Electronic soap dispense
Друкувати сторінку
TROUBLE SHOOTING:
• Change batteries to be sure there is full power.
• Is the dispenser to close to the counter or near obstructions? Be sure
dispenser has 12" (30 cm) or more distance below it. Make sure there
is nothing under or to close to the dispenser's senor.
• Be sure there are no bright lights or sun reflections. This can cause the
dispenser to halt. Try relocating dispenser to another area.
• Check the sensor below the dispenser. Clean off any possible soap
build up or other liquids that may be blocking the sensor or clogging
the soap outlet.
• Make sure the users hand is placed close to the detection area.
12" Min.
(30 cm)
INDICATOR LIGHT INFORMATION:
• Green light flashing once every three seconds - Stand By Mode.
• Solid green light - Power on and working.
• Red light flashing quickly - Interference with sensor signal.
• Red light flashing slowly - Low batteries.
• Solid red light - Low soap level.
Detection
Power
Detection Distance
Activation Time
Working Time
Capacity
Material
Installation
Dimensions
Weight
IMPORTANT NOTE:
The dispenser bottom MUST have a
clearance of 12" (30 cm) or more below
the sensor without interference. This can
cause the dispenser to halt. Remove any
interference or relocate. The dispenser
will be in auto-power on.
TECHNICAL SPECS:
Infra-Red Sensors
4 "AA" Batteries (Not Included)
Preset at 1-3" (2.5-7.5 cm)
1 second
1 Second
20 oz. (600 ml)
Stainless Steel/ABS
Wall Mounted
3.75"x4"x8" (95x100x203 mm)
1 lb. (540 kg)