Doug Fleenor Design RERUN-R3 Посібник користувача - Сторінка 7
Переглянути онлайн або завантажити pdf Посібник користувача для Обладнання для запису Doug Fleenor Design RERUN-R3. Doug Fleenor Design RERUN-R3 12 сторінок. Rackmount dmx512 recorder
Друкувати сторінку
PLAYBACK OF SHOWS
Recorded shows may not be played when there is incoming DMX512. When DMX512 from a console is
present, the Rerun Rackmount's RED LED will be on and the only action possible is recording of a show.
Playing a show
Shows are played by pressing one of the [SHOW] buttons. When a [SHOW] button is pressed, the current
show will stop running, the new show will start running. The SHOW LED will illuminate adjacent to the
button that was pressed.
When a show comes to its end and looping has been enabled (the default state) the show will start over
from its START POINT. If looping has not been enabled the Rerun Rackmount will continue sending the
last levels of the show until another show is selected. The END LED will light to show that the end of the
current show has been reached.
Note:
!
If a show is playing at the time power is lost, the Rerun Rackmount will return to the start of that show when power is
restored.
Pausing a show
A running show can be paused by pressing the [PAUSE] button. When a show is paused the PAUSE LED
will be lit and the Rerun Rackmount will continue sending the current DMX512 values for that point in the
show. While paused, various show parameters can be edited. See the section on show editing for details.
A paused show can be resumed by pressing the [PAUSE] button again. The PAUSE LED will extinguish
and the show will continue playing from the point at which it was paused.
Looping a show
When a show is selected, its recorded loop status is loaded. This is indicated by the LOOP LED. The loop
status of a show can be temporarily overridden. While the show is running, push the [LOOP] button. This
will toggle the temporary state of the LOOP LED. If the show was looping, the [LOOP] button will cancel
the loop . If it was not looping, the [LOOP] button push will enable looping. Pressing the show button will
reload the recorded loop status for the show and re-start the show from its START POINT. Altering a
show's loop status while it is running is temporary. It is not recorded with the show.
Note:
!
Looping can also be recorded into the show. This is covered in the editing show parameters section of the manual.
LOCKING THE FRONT PANEL
There is an option which will allow the front panel of the Rerun Rackmount to be locked to prevent
unauthorized operation. This feature is disabled by default. When the feature is enabled, the station can
be locked or unlocked by tapping the active [SHOW] button three times. When entering the lock mode,
all of the front panel LEDs will flash once. The LEDs will not flash when exiting the front panel lock mode.
Page 7 of 12