Doug Fleenor Design E2E Посібник з конфігурації - Сторінка 2

Переглянути онлайн або завантажити pdf Посібник з конфігурації для Конвертер мультимедіа Doug Fleenor Design E2E. Doug Fleenor Design E2E 8 сторінок. Ethernet to ethernet protocol converter

Друкувати сторінку

Product Description

The Ethernet to Ethernet (E2E) device supports conversion of four universes from one Ethernet

protocol to another Ethernet protocol. The following protocols can be configured on the input

and output Ethernet interfaces:

E1.31 sACN

ArtNet v3

KiNeT

Shownet

Draft sACN

Each interface supports one of these protocols at a time.

The E2E can relieve issues of compatibility in Ethernet lighting systems where a transmitter and

receiver do not support a common protocol. In addition to handling issues of protocol support

the E2E may help with network traffic relief. The E2E uses two separate physical interfaces to

allow separation of streams and preserve network resources.

Configuration Overview

Both input and output on the Ethernet to Ethernet protocol converter are configured using two

separate web servers. These web servers may be accessed by a PC using any web browser,

and a properly configured IP address. Ethernet in and Ethernet out are initially configured for

DHCP, but will use the assigned static IP in the absence of a DHCP server.

The Node Discovery program, which is available for download at www.dfd.com may assist users

to connect to the E2E using a Windows PC. Using DHCP and Node Discovery is a simple way

to get to the configuration pages within the interface.

Below a screenshot displays the output of a successful Node Discovery with a DHCP enabled

router and both in and out connections connected on the same network with a Windows PC.

Page 2 of 8