Dahua DH-IPC-HDBW4231FN-E2-M Посібник із швидкого старту - Сторінка 10
Переглянути онлайн або завантажити pdf Посібник із швидкого старту для Камера спостереження Dahua DH-IPC-HDBW4231FN-E2-M. Dahua DH-IPC-HDBW4231FN-E2-M 16 сторінок. Dome network camera
Також для Dahua DH-IPC-HDBW4231FN-E2-M: Посібник із швидкого старту (19 сторінок)
Друкувати сторінку
Dahua Multi-sensor Wedge Dome Network Camera Quick Start Guide
Step 1
Use wrench to take down the device enclosure.
Step 2
Take out installation position map; paste it on the wall or ceiling and other mounting surfaces
according to the location cable exit, and then dig holes on the mounting surface according to the
instruction of installation position map.
Step 3
Take out expansion bolts and insert them into the mounting holes and fix them firmly.
Step 4
Adjust the location of device pedestal according to the requirement of wiring.
If it is to pull out the cable from top, it needs to dig a "Cable Exit Hole" on the mounting
surface according to installation position map.
If it is to pull out the cable from side, first it needs to remove the reserved gap on the
enclosure and then lead out the cable from the lateral cable slot which is between the
mounting surface and pedestal.
Step 5
Align the screw fixing hole on the pedestal with those of expansion bolts on the mounting surface,
and then tighten the self-tapping screws into the expansion bolts and lock them firmly, and fix the
device on the mounting surface.
Step 6
Use fixing screw to install the enclosure on the device pedestal after adjusting the device angle.
Figure 2-2
4