Baumer GIM500R Посібник - Сторінка 4

Переглянути онлайн або завантажити pdf Посібник для Аксесуари Baumer GIM500R. Baumer GIM500R 13 сторінок. Inclination sensors
Також для Baumer GIM500R: Посібник (20 сторінок), Посібник (29 сторінок), Інструкція з монтажу (2 сторінок)

Друкувати сторінку

Safety and operating instructions

Intended use

 The inclination sensor is a precision measuring device to determine angular positions and to supply the

downstream device with measured values in the form of electronic output signals. The inclination sensor

must not be used for any other purpose.

 Make sure the appropriate safety measures are present to prevent damage to persons, the system or

operating facilities in case of sensor error or failure.

Personnel qualification

 The inclination sensor must only be installed by a qualified electronics and precision mechanics.

 Observe the user manual of the machine manufacturer.

Maintenance



The inclination sensor is maintenance-free and must not be opened or modified in its electronics or

mechanical design. Opening the sensor can lead to personal injury.

Disposal

 The inclination sensor contains electronic components. At its disposal, local environmental guidelines

must be followed.

Installation



Avoid mechanical impacts or shocks on the housing.

Electrical commissioning



Do not perform any electrical modifications at the inclination sensor.



Do not carry out any wiring work when the inclination sensor is live.



Do not dock or undock the electrical connection while the inclination sensor is live.



Ensure that the entire equipment is installed in line with EMC requirements. Ambient conditions and

wiring affect the electromagnetic compatibility of the inclination sensor. Install sensor and supply cables

separately or far away from lines with high interference emissions (frequency converters, contactors,

etc.).



Provide separate power supply for the inclination sensor where working with consumers that have high

interference emissions.



Completely shield the inclination sensor housing and connecting cables.



Connect the sensor to protective earth (PE) using shielded cables. The braided shield must be

connected to the cable gland or connector. Ideally, aim at a bilateral connection to protective earth (PE),

the housing via the mechanical assembly and the cable shield via the downstream devices. In case of

earth loop problems, earth on one side only as a minimum requirement.

Supplementary information



This manual is intended as a supplement to already existing documentation (i.e. catalogue, product

information and mounting instruction).

Baumer_GIM500R_SAEJ1939_MA_EN.docx

03.19

4/13