Baumer GNAMG Series Посібник - Сторінка 15

Переглянути онлайн або завантажити pdf Посібник для Аксесуари Baumer GNAMG Series. Baumer GNAMG Series 41 сторінка. Inclination sensor with canopen interface

Друкувати сторінку
Baumer GNAMG Series Посібник

3.3.6. Layer Setting Services

In spring 2000 CiA presented a new protocol to ensure a uniform presence. Proceedings are defined under
Layer Setting Services and Protocol, CiA Draft Standard Proposal 305 (LSS).
The inclination sensor comes with the standard Node-ID 1 and standard baud rate 50 kBaud. Several
inclination sensors with the same Node-ID can be networked to the bus system. LSS is utilized to address the
individual inclination sensor.
Every inclination sensor comes with a unique serial number that it must be addressed to. Consequently, any
number of inclination sensor with the same Node-ID can be networked to the bus for init via LSS. Both Node-
ID and baud rate can be configured. LSS is only available in stopped mode.
Message structure
COB-ID:
Master  Slave : 2021 = 7E5h
Master  Slave : 2020 = 7E4h
The COB-ID is followed by a LSS command specifier and a data packet of max. 7 bytes.
COB-ID cs
Byte 1
Switch Mode Global
7E5h  04h
Mode
: 0  Operational mode
Mode
1  Configuration mode
Switch Mode Selective
The following sequence is for addressing a determined inclination sensor in the bus system
7E5h  40h
VendorId
7E5h  41h
ProductCode
7E5h  42h
RevisionNumber
7E5h  43h
SerialNumber
7E4h  44h
Mode
VendorId
: ECh
ProductCode
: Internal product code of the respective inclination sensor
RevisionNumber
: Current revision number of the inclination sensor
SerialNumber
: Unique, successive serial number
Mode
: The inclination sensor will respond in the new mode (0=Operational mode;
1=Configuration mode)
Setting the Node-ID
7E5h  11h
Node-ID
7E4h  11h
ErrCode
Node-ID
: The new Node-ID of the inclination sensor
ErrorCode
: 0=OK; 1=Node-ID beyond the range; 2..254=reserved; 255specificError
: If ErrorCode=255  application-specific error code.
SpecificError
Manual_GNAMG_CANopen_EN.doc
21.11.12
Byte 2
Byte 3
Byte 4
Reserved
reserved
Spec Error
reserved
15/41
Byte 5
Byte 6
Byte 7
Reserved
reserved
reserved
reserved
reserved
Villingen-Schwenningen, Germany
Baumer IVO GmbH & Co. KG