dough Xpress DXP-GF001 Посібник з експлуатації - Сторінка 2

Переглянути онлайн або завантажити pdf Посібник з експлуатації для Кухонна техніка dough Xpress DXP-GF001. dough Xpress DXP-GF001 8 сторінок. Bread slicer

Друкувати сторінку

INSTALLATION & SETUP

1. INSTALLATION

Put the Slicer on a stable table and make sure the Slicer seats firmly on the

table. If the Slicer vibrates seriously during operation, put paper or rubber

underneath the frame of the Slicer.

2. ELECTRICAL CONNECTION

Before making electrical connections, check the specifications on the name

plate to make sure they agree with those of your electrical service.

3. SPECIAL ATTENTION

The operator should not put his fingers into the vibrating knives. The last

bread can not be sliced easily. Please do not try to push the last bread with

finger from the chute or take out the bread from front.

PLEASE SWITCH OFF THE SLICER WHEN YOU CLEAN IT.

4. CHANGE OF BLADES

When Slicer slices the bread slowly, the blades have become dull and must

be changed.

TO DISMANTLE THE BLADES

1. Take off Top cover (9).

2. Take off Outgoing Chute (10) secured by 4 Screws,

3. Loosen the screws on Bracket (6) Remove Outfeed Guides (7).

4. Remove Guide Rod (33) by backing off Screw and JUST loosening

Locking Nut. 5 Loosen 4 Screws on part (40) to remove Blade Frames

(25) and (26)

6. Compress Spring (30) to take out Blade one by one. You can use C-Clamp

or Vice Grips to compress Spring. Cut slot in tool, thickness of Blade to be

able to slip over Blade to be able to compress, Special Tool is available

upon request, Part Number GF001/BL/001