Com-Power AB-100 Посібник - Сторінка 10

Переглянути онлайн або завантажити pdf Посібник для Антена Com-Power AB-100. Com-Power AB-100 13 сторінок. Biconical, 30 - 300 mhz

Setup Procedure

2.0 Introduction

2.1.1 Connecting

2.1.2 Antenna setup for receiving signals

2.1.3 Antenna setup for transmitting signals

This section explains the following:

Introduction

Setup

This section describes antenna setup and mounting for EMI measurement.

The Model AB-100 and Model AB-900 biconical antennas have BNC (f) connec-

tors. The AB-100 connector is for antenna output only; the BNC connector in

Model AB-900 biconical antenna is used for both signal input and output.

The Model AB-100 or Model AB-900 antenna can be used to measure EMI from

an equipment under test (EUT). The antenna is mounted on either an antenna mast

(Model AM-400) or an antenna tripod. The antenna balun has 1/4 inch x 20

threaded hole for mounting on AT-100 tripod or any similar tripod. A cable is used

to connect the antenna to the a measureing instrument. If a long cable is used, cable

loss must be measured and used in calculating the field strength.

The Model AB-900 antenna can be used to receive and transmit signals. The

antenna is mounted on either on an antenna mast (Model AM-400 antenna mast ) or

antenna tripod (Model AT-100). To transmit signals, the antenna is connected to a

signal generator and power amplifier. The Model AB-900 biconical antenna can

transmit up to 50W continious power. The field generated by the antenna can be

measured by using a field strength meter.

2 - 1

AB-900 Biconical Antenna