Dahua F Series Посібник із швидкого старту - Сторінка 12

Dahua HD Megapixel Indoor Network Camera Quick Start Guide

2 Installation

Figure 2-1

Step 1

Remove the CCD protection cover on the device, aim the lens at the lens installation position,

and turn the lens clockwise until it is installed firmly.

Step 2

Insert the lens cable plug into the connector of auto aperture lens on the camera side panel.

Step 3

Make the image clear via adjusting focal length.

2.1.2

Please follow the steps listed below for auto aperture lens installation.

Step 1

Remove the CCD protection cap of the device,

Step 2

Install the C/CS adapter ring on the camera; turn clockwise to the end to cling to the focusing ring

on the camera closely. (Only C lens needs to install adapter ring)

Step 3

Aim the C port lens at the lens installation position of the C/CS adapter ring (aim the CS port

lens at the lens installation position of the camera focusing ring); turn the lens clockwise until it is

firmly installed.

Step 4

Use slotted screwdriver to unfasten the screw near the focusing ring and then turn counter

clockwise to move the focusing ring out for several millimeters. Now you can focus manually and

check the video is clear or not. If you can't see the clear video, you can adjust back focus.

Step 5

After you completed the focus setup, use the slotted screwdriver to fix the screw firmly. Fasten

the focusing ring. Now the installation completed.