Dahua F Series Посібник із швидкого старту - Сторінка 5

4 Device Installation

Important

Before the installation, please make sure the installation environment can at least support 3x weight of

the camera.

Step 1

Use inner hex wrench in the accessories bag to open dome enclosure by unfastening three inner hex

screws on enclosure.

Step 2

Please take out the installation position map in the accessories bag, and then paste it on the ceiling or

the wall according to your monitor area requirements.

Step 3

Find cross signs on the map, and dig three plastic expansion bolts holes on the installation surface

and then insert three expansion bolts in the holes. Secure these three bolts firmly.

Note:



If user pulls out cable from top of installation surface, you must dig an exit hole on installation

surface according to the installation position map.



If user pulls out cable from side of cable channel, it must go through the U-shape channel on

dome pedestal, and take out cable from the side exit hole on pedestal.

Step 4

Adjust the device installation pedestal to the proper position and then pull cable through the exit hole

on Installation surface. Make direction of TOP sign same as it on installation position map. Line up the

three screw holes in the device pedestal to the three plastic expansion bolt holes in the installation

Figure 4-1