Dahua F Series Посібник із швидкого старту - Сторінка 10

Dahua HD Fisheye Panorama Network Camera Quick Start Guide

Step 1

Take the installation position diagram from the accessories bag and then paste it on the installation

ceiling or the wall according to the monitor area.

Step 2

Please dig three bottom holes of the plastic expansion bolts according to the diagram. If you need to

dig a hole to pull through the cable on top of installation surface, you need to dig a cable exit hole of no

less than 28MM on the installation surface according to the installation positioning diagram, which

makes the network cable go through.

Step 3

Insert 3 expansion bolts from the accessories bag into the bottom holes and lock them firmly, adjust

the position of device installation pedestal and pull the cable through the cable exit hole on the

installation surface.

Step 4

Aim 3 screw fixed holes on the installation chassis to 3 plastic expansion bolt fixed holes on the

installation surface, then tighten 3 ST3 self-tapping screws into 3 plastic expansion bolts and fasten

them firmly, fix the installation chassis on the installation surface.

Step 5

When installing dome body, find the little gap on the dome body and make it corresponding to the

"TOP" direction on the installation chassis, rotate the dome body in clockwise direction and secure it

firmly. So far, installation is completed.

Note:

If connect the host GND to ground lead, it may improve device reliability. The GND locates next to exit

hole on the rear side of the chassis and the GND screw is M2.5.

2.2 Micro SD Card Installation

Figure 2-1

Figure 2-2