Dahua F Series Посібник із швидкого старту - Сторінка 11

Dahua HD IR Bullet Network Camera Quick Start Guide

Note



Vari-focal series devices are equipped with motorized vari-focal lens by

default, it doesn't need to adjust manually. For the device with manual

focusing lever, it supports focus and zoom via turning focusing lever.



Long press the reset button for 4~5 seconds to realize device reset function.

Install back the lower cover, twist the screw and tighten it firmly.

Step 2 Fix the device on the installation surface.

Take out the installation position map from the accessory bag, paste it on

the installation surface (wall or ceiling) and dig holes according to the hole

sites marked on the installation position map.

Take out the expansion bolts from the accessory bag and nail them into the

holes you just dug.

Take out the self-tapping screws from the accessory bag, align the

mounting holes on the device bracket bottom with the expansion bolts

which have been well dug, and then use self-tapping screws to fix the

device on the mounting surface (wall or ceiling).

Step 3 Connect the external cable well according to the requirements.

Find the corresponding power, audio cable, alarm input output port of the



device cable, and connect them well according to requirements, then twine

each cable connection location with insulated rubber tape to make it

waterproof.

Please connect the network cable to the corresponding network port of the



device according to actual needs by referring to step 4 of installing

waterproof connector.

Step 4 (Optional) Install waterproof connector for network port, which is shown in

Figure 2-3.

Note

Figure 2-2