Com-Power ACS-230-25W Інструкція з експлуатації - Сторінка 15
Переглянути онлайн або завантажити pdf Інструкція з експлуатації для Підсилювач Com-Power ACS-230-25W. Com-Power ACS-230-25W 15 сторінок.
Друкувати сторінку
9. Please refer below Diagnostics chart to check fault conditions
FAULT
SR.#.
LIGHT LIT
1
Current
2
Temperature
Power
3
Supply
RF Input /
4
RF Output
5
VSWR
Distributed by: Reliant EMC LLC, +1 408 916‐5750, [email protected], www.reliantemc.com
MESSAGE ON
LCD SCREEN
PA CURRENT
RANGE
EXCEEDED
Indicates that the current
OR
through the module exceeds
DRIVER
6.3 Amperes or the driver
CURRENT
current exceeds 1.2 Amperes.
RANGE
EXCEEDED
PA
TEMPERATURE
RANGE
Indicates that the
EXCEEDED OR
temperature range of the
DRIVER
module or driver has risen
TEMPERATURE
higher than 65
RANGE
EXCEEDED
Indicates that the DC power
POWER SUPPLY
supply is not working
BAD
properly.
RF INPUT
EXCEEDS
+3 dBm
Indicates either input or
OR
output power has exceeded
RF OUTPUT
internal limit.
EXCEEDS
+45 dBm
Indicates that the reflected
power to the Power amplifier
Reflected Power >
has exceeded internal limits.
21 Watts
Page 15 of 15
FAULT
POSSIBLE CAUSE
Power limit was exceeded
* Mismatch on 50-ohm
System
* VSWR of the system is too
high
* Mismatch on 50-ohm
system
* VSWR of the system is too
C
high
o
* DC power supply failed
* AC input zero cross
detector failed
* Excessive current draw
due to device failure.
* Input power limit was
exceeded.
* Output power limit was
exceeded.
* Check output connection
of unit and connected
system.
MANUAL_ACS-230-25W Rev. M02.15