Baumer EAM ST Series Посібник - Сторінка 17

Переглянути онлайн або завантажити pdf Посібник для Конвертер мультимедіа Baumer EAM ST Series. Baumer EAM ST Series 28 сторінок. Absolute encoder with canopen

Друкувати сторінку
9.2

Redundant encoder

Figure 6: Dataflow of Error, Alarm, Warning, Diagnostic and Emergency messages (each node)
Bus Active
CAN-Controller
Bus Warning
Bus Passive
Bus Off
RX Buffer Overflow
CAN Node Guarding or Heartbeat
Temperature Montioring
Multiturn Magnetic Field sequence
OR
Multiturn Magnetic Field strength
Non-Volatile Data Manager
Multiturn Communication Monitor
Battery Monitoring Error
OR
Multiturn Power On Reset
Speed Monitoring
Reset Reason Watchdog
Battery Monitoring Warning
Singleturn Magnetic Field strength
Singleturn/Multiturn Supervision
Emergency Message
9.3

Error behavior

The error behaviors are executed when the corresponding bit in object 1001 Error register is set and the device is in the
NMT-State Operational.
Example:
The error behavior 1029h-2 is set to "Change to Pre-Operational" (0). The device is in NMT state Operational
1.
Generic error bit is set.
→ The device changes to Pre-Operational
2.
The device is forced to NMT state Operational with NMT command Start
→ The device changes again to Pre-Operational if the generic error bit is not cleared.
Baumer_EAM580_360_CANopen_MA_EN_Rev0003.0000h_Index0004.docx
06.08.2018
Reset
OR
R
D
S
OR
no
R
Only at
D
Startup
S
R
Only at
D
Startup
S
R
Only at
D
Startup
S
no
R
Only at
D
Startup
S
R
D
S
R
D
S
Only at
Runtime
R
D
S
Only at
Runtime
Only at
Runtime
OR
Only at
Runtime
R
D
S
R
D
S
Error Register 1001h
Bit 4: Communication Error
Bit 3: Temperature
Bit 0: Generic Error
OR
Alarms 6503h
OR
Bit 0: Generic Position Alarm
Bit 1: Commissioning diagnostic
Bit 12: Position Data not valid
Bit 15: Battery empty
Warnings 6505h
Bit 0: Frequency exceeded
Bit 2: CPU Watchdog
Bit 3: Operating time limit
Bit 4: Battery charge low
Bit 12: Mounting Error
Bit 13: Multiturn System
Bit 14: Singleturn System
Bit 15: Multiturn Supervision
17/28
Error Behaviour
16-Bit Encoder Diagnostics 2117h
1029h-1h
Bit 12: Communication Error
Bit 13: Temperature
Error Behaviour
1029h-3h
Error Behaviour
1029h-1h
Bit 10: Generic Position Alarm
Error Behaviour
1029h-2h
Bit 11: Commissioning diagnostic
Bit 14: Position Data not valid
Bit 15: Battery empty
Bit 0: Frequency exceeded
Bit 1: CPU Watchdog
Bit 2: Operating time limit
Bit 3: Battery charge low
Bit 4: Mounting Error
Bit 5: Multiturn System
Bit 6: Singleturn System
Bit 7: Multiturn Supervision
Baumer Electric AG
Frauenfeld, Switzerland