Douglas Dynamics SnowEx HDV 77775 Інструкція з монтажу Посібник з монтажу - Сторінка 13

Переглянути онлайн або завантажити pdf Інструкція з монтажу Посібник з монтажу для Автомобільні аксесуари Douglas Dynamics SnowEx HDV 77775. Douglas Dynamics SnowEx HDV 77775 16 сторінок. Snowplow

Друкувати сторінку

1. Installation Instructions

OPERATIONAL TEST AND FINAL ADJUSTMENTS

CENTER CUTTING EDGES

The center cutting edge spacer plate is located on the

T‑frame below the pivot pin hinges.

1. With the blade wings in straight position, the center

cutting edges should touch the center cutting edge

spacer plate. If they do not touch the spacer plate,

adjust the center cutting edges as follows.

2. Loosen the four 5/8" x 2" center cutting edge

carriage bolts, but do not remove them.

3. Slide the center cutting edges inward until they

contact the spacer plate.

4. Re‑tighten the center cutting edge carriage bolts

according to the torque chart.

5/8" x 2"

Carriage

Bolts

Center Cutting Edges

Lit. No. 52592, Rev. 04

Spacer Plate

LUBRICATING THE PIVOT PIN HINGE

Using a rubber-tipped seal-off coupler tip, apply a

good quality multipurpose grease at the five grease

points along the center pivot pin hinge.

Grease

Points

July 15, 2020