Douglas Dynamics SnowEx HELIXX 1.5 yd3 Інструкція з монтажу Посібник з монтажу - Сторінка 11

Переглянути онлайн або завантажити pdf Інструкція з монтажу Посібник з монтажу для Розкидач Douglas Dynamics SnowEx HELIXX 1.5 yd3. Douglas Dynamics SnowEx HELIXX 1.5 yd3 19 сторінок. Poly hopper spreaders

Друкувати сторінку

WIRING INSTRUCTIONS

Spreaders are shipped from the factory with the

spreader harness wired to the motor and spreader

module.

To properly wire the hopper spreader, follow this

recommended installation sequence:

1. Install the vehicle battery cable and control

harness included with the spreader, following the

steps given below.

2. Install the cab control as described under "Cab

Control Installation."

NOTE: Use dielectric grease on all electrical

connections.

Lit. No. 74041, Rev. 00

WIRING AND HARNESS INSTRUCTIONS

Vehicle Battery Cable Installation

1. Before beginning this installation, remove the

battery cables from the vehicle battery.

2. Using the 1/4" x 3/4" cap screws, 1/4" flat washers,

and 1/4" locknuts, mount the fuse holder near

the vehicle battery so that the 22" battery cable

can be installed from the POSITIVE (+) battery

terminal to the fuse holder. Install the fuse into the

fuse holder and hand tighten the nuts.

3. Attach one end of the 22" battery cable to the fuse

holder so that the ring terminal is on top of the

fuse. Replace the lock washer and nut.

4. Lay out a path for routing the vehicle battery cable

from the rear of the vehicle bed to the vehicle

battery. Make sure that the path avoids any hot,

sharp, or moving parts of the vehicle. Routing will

vary from vehicle to vehicle.

5. Route the vehicle battery cable as laid out in Step 4.

6. Using cable ties, secure the battery cable to

the vehicle. Verify that the harness cannot drop

onto the road when it is disconnected from the

spreader.

Attach the vehicle battery cable red wire to the

other fuse holder stud so that the ring terminal is

on top of the fuse. Replace the lock washer and

nut.

8. Torque the fuse holder nuts to 106–159 in‑lb and

snap the fuse holder cover into place.

9. Attach the other end of the 22" battery cable to

the POSITIVE (+) battery post.

10. Attach the vehicle battery cable black wire to the

NEGATIVE (–) battery terminal.

June 15, 2019