Douglas Dynamics SnowEx HELIXX 2.25 yd3 Інструкція з монтажу Посібник з монтажу - Сторінка 12

Переглянути онлайн або завантажити pdf Інструкція з монтажу Посібник з монтажу для Розкидач Douglas Dynamics SnowEx HELIXX 2.25 yd3. Douglas Dynamics SnowEx HELIXX 2.25 yd3 19 сторінок. Poly hopper spreaders

Друкувати сторінку

Vehicle Control Harness Installation

1. Plug the vehicle harness into the spreader harness.

2. Lay out a path for routing the vehicle control

harness from its attachment point on the vehicle

battery cable into the cab of the vehicle. Make sure

that the path avoids any hot, sharp, or moving parts

of the vehicle. Routing will vary from vehicle to

vehicle.

3. Choose a cab control mounting location that can

be reached by the harness. The location must

be within easy reach of the vehicle operator

without restricting access to vehicle controls or

instrumentation.

Do not mount the control in areas prohibited

by the vehicle manufacturer for reasons of

crashworthiness. See the vehicle's body builder's

book, owner's manual, or service manual for

details. The shaded portions in the illustration

below show the most commonly restricted areas.

CAUTION

Do not alter, modify, or install additional

components in shaded areas shown below.

Failure to comply may interfere with airbag

deployment or cause injury to operator in an

accident.

CAUTION

Before drilling any holes, check both sides

of the material for any wires, fuel lines, fuel

tanks, etc., that may be damaged by drilling.

4. Drill a 5/8" hole in the fire wall so that the vehicle

control harness can reach the desired cab control

location.

Lit. No. 74041, Rev. 00

WIRING AND HARNESS INSTRUCTIONS

5. Insert a rubber grommet into the hole.

6. Route the harness as laid out in Step 2.

Secure the vehicle control harness to the vehicle.

8. Attach the red wire to a switched accessory circuit.

Cab Control Installation

1. Confirm that the chosen cab control mounting

position will not interfere with other equipment or

allow unintentional starting of the spreader.

2. Install the vehicle side of the mounting bracket

using three #10 x 3/8" Phillips head tapping

screws.

#10 x 3/8"

Tapping

Screws

Control Side

(Control not shown.)

3. Install the control side of the bracket to the control

using four #8 x 3/8" Phillips head machine screws.

Vehicle Side

#8 x 3/8"

Machine

Screws

June 15, 2019