Douglas Dynamics SnowEx V-Pro SP-2000 Інструкція з монтажу Посібник з монтажу - Сторінка 10

Переглянути онлайн або завантажити pdf Інструкція з монтажу Посібник з монтажу для Розкидач Douglas Dynamics SnowEx V-Pro SP-2000. Douglas Dynamics SnowEx V-Pro SP-2000 17 сторінок. Utv hopper spreader

Друкувати сторінку

WIRING INSTRUCTIONS

1. Remove the vehicle ﬂ oor pan and battery cover. If

possible, tip up the bed and lock it in place.

2. Route the vehicle cable assembly along the vehicle

frame from the rear of the vehicle to the front. Make

sure that the path avoids any hot, sharp, or moving

parts of the vehicle. Cable tie the harness to the

frame holes and frame supports. Do not attach to

fuel or brake lines.

3. Mount the rear plug to the bumper using the

supplied bracket and fasteners. Position the

plug toward the center of the bumper to reduce

exposure to debris thrown up by the tires.

4. Install the dust cover and secure the pigtail to

the harness mounting bracket using the existing

fasteners.

NOTE: Apply a small amount of dielectric grease

to the plug. Try to mount the plug facing upward

to help keep it tightly sealed.

Lit. No. 76451/76452/76453, Rev. 04

WIRING AND HARNESS INSTRUCTIONS

5. Route the ignition wire and connect it. Consult

UTV wiring diagram to locate a suitable ignition

wire connection. Secure the harness from the rear

to the battery using heavy-duty cable ties or frame

clips along the frame and lighter duty cable ties

everywhere else. Attach the relay assembly to the

fender wall in a safe area.

Before drilling any holes, check both sides

of the material for any wires, fuel lines, fuel

tanks, etc., that may be damaged by drilling.

6. Pass the remaining harness into the cab under

the ﬂ oor pan. On the passenger's side of the

centerline of the UTV, at the lower portion of the

front cab where the ﬂ oor mats meet the ﬁ re wall,

choose a location for the harness to be routed

into the cab. Before drilling, check the area on

the other side of the ﬁ re wall to make sure that no

wiring or control module could be damaged.

Drill and slot a 1" hole such that the harness can

pass into the cab when the ﬂ oor pan is reinstalled.

Connect power leads to the battery:

Red: POSITIVE (+)

Black: NEGATIVE (–)

Always connect to the primary battery if using a

dual battery system. Secure loose loom to any

other large or medium vehicle harness using

medium-duty cable ties to secure the wiring

harness.

CAUTION

February 24, 2020