Comanche BITS Інструкція з експлуатації - Сторінка 5
Переглянути онлайн або завантажити pdf Інструкція з експлуатації для Інструменти Comanche BITS. Comanche BITS 6 сторінок. Bungee installation tool system
Друкувати сторінкуthe stretched bungee. Extend the installer tool to align
the ring pin holes and re-insert the ring pin.
8. Screw the hex drive clockwise to retract the outboard
arm, which will engage the bungee cord onto the
installer tool. You can now unfasten the bolt from the
outboard bungee arm. The installer tool is now
"loaded" with a new bungee and ready to install in the
wing.
1. Place the loaded installer tool into the bungee access
opening with the bolt pointing outboard and visually
line it up with the nut plate hole. Screw the bolt into
the nut plate as far as it will go. You may have to back
off one-quarter turn to align the bungee parallel to the
inboard pulley.
2. Place the inboard end of the installer tool over the
bungee arm pulley.
3. Slowly lower the landing gear until the landing gear
bungee arm is extended straight out and lined up with
the bungee cord itself. The bungee cord will now be
engaged on the inboard pulley.
4. Pull the detent ring pin and collapse the installer tool.
Remove the installer tool from between the bungee
halves.
5. Repeat the process on the other wing.
6. Perform a gear retraction/extension test and verify the
gear and gear indicating systems both function
normally. Be certain the landing gear is down and
locked before removing the plane from jacks.
Installing the New Bungee