Baumer PAC50H Посібник з експлуатації - Сторінка 16

Переглянути онлайн або завантажити pdf Посібник з експлуатації для Вимірювальні прилади Baumer PAC50H. Baumer PAC50H 44 сторінки.

Electrical installation

8.1

8.2

Condition:

ð Mains voltage supply must be within the admitted sensor limits (11 - 35 V

ð Power supply provides external overload protection.

ð Connections will use only approved fire protection cables.

ð Any long or hanging cables are secured by approved fastening systems.

ð All electrical connections are clean.

CAUTION

Risk of damage to equipment by electric current

NOTICE

Risk of damage to equipment by contamination

NOTICE

Damage to seal or push-in fitting

Excessive tightening of the union nut may damage the connection or the O-seal provided at the

M12 cable.

a) Tighten the union nut to a maximum torque of 0.6 Nm.

b) Never use any tools to tighten the union nut.

NOTICE

Observe circuit diagram

Observe the wiring and circuit diagrams when preparing electrical connection.

Instruction:

a) Make sure the higher-level machine is safely switched off and not under supply.

If necessary, disconnect the higher-level machine and secure the control cabinet against in-

advertent power-on.

b) Connect the sensor to the control cabinet using the connector.

c) Ensure correct pin assignment.

Vs +

GND (0 V)

Select

Iout + / SW2

IO-LINK / SW1

Operating Manual

Power supply (+)

Power supply (-)

Select range: R1 or R2

Select output: conductivity or temperature

4 ... 20 mA

Conductivity / temperature / SW

IO-Link / SW

Baumer

PAC50H/S | V1