Baumer VEXU Series Посібник із швидкого старту - Сторінка 2
Переглянути онлайн або завантажити pdf Посібник із швидкого старту для Цифрова камера Baumer VEXU Series. Baumer VEXU Series 2 сторінки.
Друкувати сторінкуGeneral Description
1
4
3
No.
Description
No.
Description
1
Lens mount (CS-mount)
4
LED
2
Digital IO
3
USB 3.0 port
Data Interface / Digital IOs
USB 3.0 (Micro B)
1 2 3 4 5
6 7 8 9 10
1
VBUS
2
D-
3
D+
4
ID
5
GND
10
Digital-IOs (on camera side)
wire colors of the connecting cable (ordered separately)
2
1
4
3
1
Power IO
brown
3
GND
2
IN1 (Line0)
white
4
OUT1 (Line1)
LED signals
2
LED
Installation
Installing the camera:
▪ Connect the camera to the USB connection on your PC using an appropriate
cable.
▪ If required, connect a trigger and / or flash to the digital IOs.
6
MicB_SSTX-
7
MicB_SSTX+
8
GND_DRAIN
9
MicB_SSRX-
MicB_SSRX+
open wire
blue
black
Installation example
1 - PCI USB board
2 - USB cable
3 - Cable for trigger and flash
LED
Signal
Meaning
green flash
Power on
green
USB 3.0 connection
red
USB 2.0 connection
yellow
Readout active
red flash
Update
Heat Transmission
Caution
Heat can damage the camera. Heat must be dissipated adequately
to ensure that the temperature does not exceed the values in the
table below.
As there are numerous possibilities for installation, Baumer recom-
mends no specific method for proper heat dissipation, but suggest
the following principles:
▪ operate the cameras only in mounted condition
▪ mounting in combination with forced convection may provide
proper heat dissipation
T
Measurement Point
Maximum Temperature
Measurement Point (T)
65°C (149°F)
Troubleshooting
1. Check camera operation using the LED signals.
→ If LED is red:
• Camera is connected to USB 2.0 (settings possible).
2. Check connection using Windows Device Manager:
→ If device is not listed:
• Check the host controller power supply.
• Check USB 3.0 cable and connection.
→ If device is regularly not listed
• Check USB 3.0 driver installation.