AMPHIBICO PHENOM NX5 SE Інструкція з експлуатації - Сторінка 9

Переглянути онлайн або завантажити pdf Інструкція з експлуатації для Аксесуари для фотоапаратів AMPHIBICO PHENOM NX5 SE. AMPHIBICO PHENOM NX5 SE 14 сторінок. Video camera housing sony hxr-nx5 & sony hdr-ax2000

Друкувати сторінку

One of the buttons (shown on the right) on the control panel

located on the left side of the unit behind the grip activates

and dis activates the camcorder's menu.

Picture Profile

One of the buttons (shown on the right) on the control panel

located on the left side of the unit behind the grip activates

and dis activates the camcorder's menu.

Navigation Function (NAV)

To change any of the settings inside the menu or to select a

picture profile, you need to activate the navigation function

(NAV) first. This is done as follows:

Hold down the shift key while pressing down on the right grip

trigger button to activate and dis activate the NAV function.

The NAV light indicator will turn on steady green when

activated. Use the UP, DOWN, LEFT & RIGHT arrows on the

right grip buttons to navigate through the menu. The execute

button is the right grip trigger button.

Toggle NAV mode

Left Grip

and NAV execute

Trigger button (shift key)

Right grip trigger button

Assign Buttons

You can also access the camcorder's assign buttons via the

control panel. The available assign buttons are found on the

control panel as follows.

S3:

Assign 1

S4:

Assign 2

Shift S1: Assign 4

Shift S2: Assign 5

Shift S3: Assign 6

HOUSING & CAMCORDER OPERATION

Picture Profile

Right Grip

Control Panel

INSTALLING THE SADDLE

Place the saddle under camcorder with its handle pointing

the back of the camcorder. Align the thumb screw's saddle

and guide pin with the camcorder's tripod mounting holes.

Hand tighten the thumb screw to secure the saddle to the

camcorder.

CONNECTING THE SADDLE

LANC: Connect the cable from the rear of the saddle to the

camcorders LANC jack.

AUDIO: Connect the adapter plug (supplied) to the

camcorder's INPUT 1 MIC jack. Connect the audio cable

from the front of the saddle to adapter plug.

NOTE: It is important to route the LANC and AUDIO cables

up and over the camera as shown. This will prevent these

cables from getting damaged when inserting the camera into

the housing. See Tips & Tricks on page 19 of this manual for

additional safety precautions.

Connecting the LANC

LANC

PREPARING CAMCORDER & HOUSING

Installing

Thumbscrew

Connecting the AUDIO

INPUT 1