Amphony Model 400 Посібник з експлуатації та встановлення - Сторінка 6

Переглянути онлайн або завантажити pdf Посібник з експлуатації та встановлення для Передавач Amphony Model 400. Amphony Model 400 13 сторінок. 5.8 ghz multi channel audio transmitter

Друкувати сторінку

User and Installation Guide

Step 2

Placing the transmitter

Ideally, the transmitter should be placed at an elevation such that there

are no obstacles between the transmitter and wireless receivers or

amplifiers (line of sight) in an area where there will be the least amount

of traffic. We suggest that you place the transmitter on top of your audio

source.

Step 3

Operating the transmitter

The green transmit light of the transmitter will be on when audio is

transmitted.

If you are using the speaker outputs, adjust the audio level of your audio

source to the maximum level where no clipping / distortion occurs at the

wireless receivers.

If the audio level supplied to the transmitter is too high, then distortion

will occur. If the audio level is too low, the dynamic range of the

transmission will not be used and the audio level at the receiver may be

too low.

If you are using a line-level audio output and the audio level is too low,

try instead using an audio output with audio volume regulator such as a

headphone output. The transmitter can connect to a headphone output

by using a phone jack-to-phone jack cable.

If audio reception is poor, try raising the transmitter and changing the

transmitter location until reception is acceptable.

If no audio signal is present, the transmitter will go into standby mode

after approximately two minutes. The transmitter will wake up as soon as

an audio signal is present.

Page 6