Dovre 500cc Посібник з монтажу та експлуатації - Сторінка 4

Переглянути онлайн або завантажити pdf Посібник з монтажу та експлуатації для Дров'яна піч Dovre 500cc. Dovre 500cc 19 сторінок.

-2-

2. NOW GENTLY LAY THE UNIT ON ITS BACK AND ATTACH THE LEGS AND ASH LIP (SEE FIG.!).

3. INSTAll

flOOR PROTECTION IF THE HEATER IS BEING PLACED ON A COMBUSTIBLE FLOOR.

REFER TO THE SECTION ON FLOOR PROTECTORS FOR REQUIRED MATERIALS AND SIZES.

4. LIFT -

DO NOT liLT ON THE CAST IRON LEGS-

THE UNIT TO THE UPRIGHT POSITION

AND PLACE IT ON THE FLOOR PROTECTOR.

5. REPLACE THE 3 BURN PLATES, LOO RETAINERS, GRATES, AND ASH PAN INSIDE THE STOVE

(SEE FIG. 2).

SIDE BURN

PLATE

BACK BURN

PLATES

LOG RETAINER

FIG. 2

FIG. 1

6. RETURN THE GLASS DOOR AND THE SIDE LOADING DOOR TO THEIR HINGES. ATTACH THE

4 SPRING HANDLES TO THE 3 DOOR LATCHES AND BYPASS DAMPER LEVER.

7. THE FLUE COLLAR IS LOCATED IN THE BOX THAT WAS INSIDE THE HEATER. FOR A TOP FLUE

EXIT, ATTACH THE COLLAR TO THE TOP OF THE HEATER WITH BOLTS AND NUTS PROVIDED.

FURNACE CEMENT MAY BE USED TO SEAL UNDER THE COLLAR (SEE FIG.3). SHOULD A REAR

FLUE EXIT BE NECE~RY

YOU WILL NEED TO REMOVE THE BACK SHEET METAL COVER

PLATE FROM THE BACK SHIELD.

THE FLUE COLLAR IS THEN FASTENED TO THE BACK OF

THE UNIT WITH THE BOLTS AND NUTSPROVIDED,AS

SHOWN IN FIG. 3. INSTALL THE CAST

IRON COVER PLATE ON THE TOP OF THE HEATER IN THE UNUSED FLUE OPENING BY PLACING

A BEAD OF FURNACE CEMENT AROUND THE EDGE AND PLACE THE COVER IN POSITION SO IT

SITS FIRMLY AGAINST THE CAST IRON. FOR ATTACHING THE COVER PLATE TO THE REAR OF

THE STOVE, YOU WILL ALSO NEED TO ATTACH THE FIXING BAR TO THE COVER PLATE WITH

THE BOLT AND WASHERS PROVIDED. SEE FIG. 4 FOR TOP COVER PLATE AND FIG. 5 FOR

REAR COVER PLATE INSTALLATION.