Dovre 700 Інструкція з монтажу та інструкція з експлуатації - Сторінка 10
Переглянути онлайн або завантажити pdf Інструкція з монтажу та інструкція з експлуатації для Дров'яна піч Dovre 700. Dovre 700 14 сторінок.
Друкувати сторінку
5.
Maintenance
It takes little effort to keep your stove in good condition.
Regularly check whether the sealing cord still closes the doors tightly enough.
The painted or enamelled cast iron mantle can be cleaned with a moist, soft cloth,
when it is almost cold.
Minor paint damage can be touched up with a can of spray paint. Your dealer can
supply you with the correct spray product. For enamel damage, small repair kits of
appropriate colour are available from your dealer. Make sure no aggressive, acid
products get in touch with enamelled parts.
During the first use after repainting your unit might give off some slight odour.
However, this will disappear quickly.
The glass can be cleaned with a number of glass cleaning products available from
your dealer. Your installer can also supply you with appropriate products. However,
never use abrasive or corrosive cleaning products.
At the end of the heating season, seal off the chimney with a ball of paper. You can
then thoroughly clean the stove on the inside.
If necessary, replace the sealing ropes and use fire cement to fill
up possible leaks.
Remove the fire plate for better and more thorough cleaning.
You should have your chimney swept by an expert before the heat-
ing season begins. It is also useful to check the chimney for soot
during the heating season and to check for blockage of the chim-
ney flue prior to re -lighting after a prolonged shut down period.
Checking and maintaining the chimney is a statutory requirement.
When all of the above advice is heeded, you will be able to fully
enjoy your stove.
Door adjustment:
The door is fully adjustable to ensure air tightness and correct
alignment.
To make adjustments, use the following procedure.
Loosen the two hex headed screws located on the right outside
front of the firebox. To achieve a tighter door seal, the adjusable hinge plate may be
moved forward or backward fom the top and/or bottom. Horizontal adjustment can
be made firstly by loosing the two hax headed
screws. Tightening the top screw will raise the
door if it sags and does not latch smoothly. Loos-
ening the top screw will lower the opposite adge
if the door is too high. Adjusting both set screws
wil re-position the door to the left or right for
correct alignment. After adjustments have been
made, tighten the two hew headed screws on the
hinge plate, taking care not to over tighten. The
door latch may be adjusted in a similar manner.
Removing the baffle plate:
The fire plate is fixed onto the back plate of the
stove with one bolt, visible from the outside. After having removed this bolt, you can
easily take the fire plate out of the stove. Eventually remove the refractory stones
first.
10
700
03.27838.100