Dovre 425 Інструкція з використання Установка та обслуговування - Сторінка 5
Переглянути онлайн або завантажити pdf Інструкція з використання Установка та обслуговування для Піч Dovre 425. Dovre 425 12 сторінок.
Друкувати сторінку
Thermostatic Control
2.21
The appliance is fitted with a thermostat, see Diagram 1,
which can control the room temperature between
approximately 9˚C and 34˚C. The edge of the thermostat
control dial is numbered 1 - 9 with 1 being the coolest
setting and 9 being the warmest. If the room temperature is
too high turn the thermostat dial in an anti-clockwise
direction. If the room temperature is too low turn the dial in a
clockwise direction.
Log Effect
Log effect appliances have a glass fibre fuel bed which
2.22
may give off a slight smell when first used. This is
normal and should disappear after a day or two.
Thermal Safety Cutout
The appliance is fitted with a thermal safety cutout,
which operates if it overheats. If this happens:
2.23
Unplug the appliance and allow it to cool for 5 - 10
minutes.
2.24
Check the air inlets/outlets for any obstruction and clear, see
Maintenance, Section 3.4.
2.25
Plug in appliance and switch it on. The cutout will re-set
and the appliance should function correctly. If this is not
the case:
2.26
Unplug once more and have the fire checked by a
competent electrician.
3. Maintenance
ALWAYS UNPLUG FROM MAINS SUPPLY BEFORE
3.1
CLEANING OR UNDERTAKING ANY MAINTENANCE
CLEANING
3.2
Only clean the outer casing when it is cold. Do not use
abrasive cleaners.
3.3
For painted castings, wipe with a damp cloth and buff
with a lint free duster.
CLEANING AIR INLETS
3.4
Ensure the appliance is unplugged.
3.5
Clean the air inlet and outlet grilles regularly with a soft
cloth or the nozzle of a vacuum cleaner.
Dust build-up can inhibit efficient performance of the
fan and lead to the safety cut-out operating.
3.6
Keep the area around the appliance clean and free of fluff,
dust or pet hair.
3.7
In particular, build-up of dust etc. can occur around the
heater area under the appliance. Take particular care to
keep this area free from such particles on a regular basis
to prevent build-up.
User Instructions
CLEANING LOG MOULDING
3.8
Ensure the appliance is unplugged and cold before handling
log moulding.
3.9
Follow Section 4, choosing relevant model, to access and
remove log moulding.
3.10
Dust off any build-up with a brush or damp cloth and replace.
4. Removing & Replacing Doors and
Removal of Fuel Bed
WARNING: DOOR CASTINGS ARE EXTREMELY
HEAVY - SEEK ASSISTANCE BEFORE REMOVAL.
Please note: The fuel bed is secured by 2 x screws on
the lower panel on the front of the appliance.
3
4.1
Lift the heavy top away from the appliance.
4.2
Remove the door facia.
4.3
Remove the top glass clamp and hold the glass steady.
4.4
Remove the bottom glass clamp.
4.5
Remove the glass.
4.6
Remove the fuel bed, lifting the back away from the appliance.
4.7
Replace the fuel bed taking care not to damage the
plastic screen.
4.8
Reassemble in reverse order.
4
Screws
Fuel bed
5