Follett HCC1010WMS Посібник із швидкого старту - Сторінка 7
Переглянути онлайн або завантажити pdf Посібник із швидкого старту для Льодогенератор Follett HCC1010WMS. Follett HCC1010WMS 8 сторінок. Self-contained chewblet ice machine
Друкувати сторінку
4 – Horizon Elite ice machine mounting accessories
Optional wall mount bracket
30.50"
(77.7 cm)
5 – Horizon Elite drains - specifier guidelines
Ice machine drain plumbing
silicone tubing
3/4" barb x 3/4" FPT
➋
➌
1" standpipe/drain
Chassis drain plumbing – Required
Self-contained 1010, 1410 series ice machine
Optional machine stand
22.00"
(55.9 cm)
25.50"
(64.8 cm)
➊
Minimum 8"
radius
2 ft x 1" OD
3/4" MPT x 1" slip
6.88"
(17.50 cm)
A
B
13.00"
(33.0 cm)
A - 25.2" (64.0 cm)
B - 28.7" (72.9 cm)
Important specifier notes
1. For secure wall mounting, specify
optional wall mount bracket.
2. Wall and fasteners must support the
weight of the ice machine, bracket,
supply water and ice. Use of a backing
board may be required with hollow wall
construction.
3. Machine stand mounting adds 6.88"
(17.5 cm) to height of ice machine.
4. No dips in tube routing allowed.
5. Ice transport tube needs minimum
1/4" per foot (2 cm per meter) pitch
toward ice machine and should be
secured to prevent dips and traps
from forming.
21.00"
(53.3 cm)
Important specifier notes: Where code
allows, follow recommendation below.
1. Apply Teflon tape to 3/4" male outlet ice machine
fitting. Thread on either the provided straight
3/4" barb adapter or a 90 degree adaptor.
Connect the supplied 2' (0.61 m) silicone hose to
➊
the 3/4" drain barb
.
2. It is recommended that the silicone hose be
routed down into a 1.5" or 2" standpipe/drain.
The minimum drain size for the ice machine is 1".
Note: 3/4" to 1" PVC adapter fittings are provided
if a larger drain size is not possible
Note: Minimum 8" radius on silicone drain line.
Drain line from the ice machine must have at least
1/4" per foot pitch (6.4 mm/0.3 m).
Note: Standpipe/drain provided by others. All
other components provided with ice machine.
Important specifier notes: Where code
allows, follow recommendation below.
11. Remove white 3/8" plug from rear push‑in fitting
➊
.
2. Route 3/8" OD drain tubing (preferably copper)
through rear of docking station and fully insert
into chassis base push‑in fitting. Route into drain
standpipe.
3. Gravity drain. Ensure 3/8" OD tubing slopes down
into drain standpipe without forming a trap.
➋ ➌
.
7
Form# 7030