Ampler Curt Посібник користувача - Сторінка 6

Переглянути онлайн або завантажити pdf Посібник користувача для Скутер Ampler Curt. Ampler Curt 16 сторінок. 2019

6/16

State of charge

Turning the lights on

Changing the assist modes

V1.1, 24.04.19

Power on the bike

For your protection, please read carefully "Charger

safety manual" chapter below before operating the

Ampler battery charger.

The power button also acts as a battery charge moni-

tor. The led colours according to the state of charge.

0–10% Blinking red

10–50% Transition from red to yellow

50–75% Transition from yellow to green

75–100% Green

To turn the lights ON and OFF, hold the power button

for 1–2 seconds. You can turn the lights on/off also

from your Ampler mobile app.

The bike will remember the last setting, so the lights

will be ON when you leave them on next time you

power the bike.

The bike has two standardized assist modes:

• Normal (1)–25 km/h, 250 W, 100% (max assist

speed, motor power, assist level)

• Boost (2)–25 km/h, 250 W, 150% (max assist speed,

motor power, assist level)

To switch between the assist modes, hold the power

button down for 3–4 seconds, until it turns orange.

After releasing the button, it will blink ONCE if it

changes to Normal Mode (assist mode 1) or TWICE if

it changes to Boost Mode (assist mode 2).

You can fully customise the assist modes with the

Ampler Bikes app under the 'Vehicle settings'.