CombiSteel 7450.0176 Посібник користувача - Сторінка 4

Переглянути онлайн або завантажити pdf Посібник користувача для Морозильна камера CombiSteel 7450.0176. CombiSteel 7450.0176 14 сторінок.

Note that these instructions apply to all freezers. Installations of equipment may not exactly correspond to your

model.

INSTALLATION

Make sure that the freezer is not damaged on arrival. Your supplier must be notified of any transport damage,

within 24 hours of delivery.

The freezer should be placed in a warm, dry room, with suitable ventilation. Place the freezer in such a way, as

to allow the free circulation of air around it. That is, with at least 100mm space all around it.

Never place the freezer in strong sunlight. The freezer should be placed on a level surface. Make sure that it does

not rock.

If the freezer has been stored or transported cold, it must not be started before the compressor is judged to have

reached a temperature of at least +5°C. It is recommended to clean up the freezer before starting it.

The freezer must be connected to a socket with the correct voltage/frequency, as shown on the nameplate. The

standard for Europe is 230V/50Hz. Voltage variations of ±10% are acceptable. Greater variations can damage the

freezer, and in such cases the factory warranty is not valid. In the case of extreme voltage variations, above or

below the standard, your local supplier will be able to advise you what to do.

This freezer requires extra protection according to the Danish Heavy Current Regulations.

This also applies, if a new freezer is replaced. Which did not have such protection. The purpose of extra protection,

is to protect the user from dangerous electric shocks, in the case of defect.

The temperature of the freezer is automatically regulated by a pre-adjusted thermostat.

The position of the freezer, the ambient temperature, the number of times the lid is opened and for how long;

all these factors affect the temperature in the freezer, which should therefore not be placed in sunlight or close

to a heat-radiating surface.

If your freezer is fitted with a lock, the key should be kept out of the reach of children. If your new freezer is to

replace an older one, which is not in use any more, you should remove the lock mechanism on the old one,

before disposing it.

The freezer is only designed as a conserver, and is therefore not suited to cold freeze foodstuffs. In other words,

only pre-frozen food must be placed in the freezer. Note that the freezer must not be filled beyond the height

limit of the contents line, or in cases where there is no such line, to within 100mm below the lid. This is to ensure

the product temperature is less than -18°C.