Amplificazioni Lombardi LAQUAD1200 Посібник - Сторінка 5

Переглянути онлайн або завантажити pdf Посібник для Підсилювач Amplificazioni Lombardi LAQUAD1200. Amplificazioni Lombardi LAQUAD1200 10 сторінок.

frontal description

RACK set up

There are 2 holes in the frontal panel for

the rack set up. The space of each rack

consists of 2 units.

Handles

The handles make it possible for the

amplifier to be put inside or taken out

from the rack.

Ventilation grill

The ventilation grill must not be covered

so that it can allow for air flow to be

released.

Volume power

This potentiometer regulates the channel

volume. It is important to keep it at

minimum when turning on and off the

device.

Protection

Thermal protection in case the

temperature is exceeded. Plus an output

protection that activates in case of

continuous flow or short circuit.

A M P L I F I C A Z I O N I

6 8

Regular output signal

With this led turned on the amplifier is

used correctly.

bridge

Bridge connection between channel A

and B (and/or C and D), in this case only

the A Speakon (or C) output is possible,

and the connection is 1+2+ (do not

connect less than 4 ohm load)

crossover

Filter (each channel):

filter 1 (113 hz) filter 2 (145 hz) filter 3

(3200 hz)

high cut (green) - low cut (red)

Power on / off switch

Power on and off switch of the device.

pagina 5 di 10