CombiSteel LG4-166 Посібник користувача - Сторінка 6

Переглянути онлайн або завантажити pdf Посібник користувача для Холодильник CombiSteel LG4-166. CombiSteel LG4-166 18 сторінок.

Temperature control

The temperature control is fixed on the veneer or on the tabletop of the refrigerator. As shown in figure.



For LG4-336, LG4-600 and LG4-800, when the control knob is in "OFF" position the compressor does

not operate.



For LG4-336, LG4-600 and LG4-800, the temperature control is adjusted from "1" to "6", the

temperature in the cabinet is from high to low. That is to say, when turning to "1", temperature is not

too low; while turning to "4" or "6", the temperature is the lowest.



If quick-freeze is required," set the control knob to "5" ～"6" (LG4-336, LG4-600 and LG4-800). It should

be turned back to other position. This is just for emergency use. Therefore, don't use it frequently. Its

continuous working time cannot be too long, or the temperature in the cabinet might be so low that

the bottles in the cabinet may be easily broken.

After the refrigerator has been running for some time, frost will form on the surface of the evaporator. The thicker

the frost is, the hotter resistance. The hot resistance will reduce the effect of the refrigerant. Please defrost,

when the frost is thicker than 5mm.



Please set the control knob to "OFF" or disconnect the power supply before defrosting the refrigerator.



Open the door, and take out the food. Tap the frost gently. Wait until the defrost water is drained. Please

clean with soft cloth dipped in warm water or neutral soap liquid. Be sure to wipe with pure water after

using neutral soap liquid.



Never attempt to scrape/remove ice/frost with sharp objects (such as knives, shovels, etc.). Or the

evaporator will break down.



After defrosting, connect the refrigerator to the power supply.

Sometimes you may come across minor problems that in most cases do not require a service call and can be

easily eliminated. The problem may have resulted from improper handling and/or installation of the appliance.

Please refer to the troubleshooting guide below to assist you in identifying the problem. If it still persists after

completing these checks, contact the closest authorize service agent in your area for assistance.