Amplified Nation Wonderland OD 100 V2 Посібник користувача - Сторінка 5

Переглянути онлайн або завантажити pdf Посібник користувача для Підсилювач музичних інструментів Amplified Nation Wonderland OD 100 V2. Amplified Nation Wonderland OD 100 V2 9 сторінок.

Друкувати сторінку

Front Panel Functions

(CONTINUED)

Overdrive Switch: Switches the amplifier channel, sending the instrument signal through the overdrive

channel. To enable foot switch control of this function, this switch must be down.

PAB Switch: This switch bypasses the tone controls, increasing both level and mids. To enable foot

switch control of this function, switch must be down.

Reverb: The reverb control sets the level of reverb in the mix. The reverb effect is eliminated with this

control in the full counter clockwise position and increased when turned clockwise.

Contour Control: The contour control is similar to a 'cut' control. In the 12 o'clock position, the amps'

frequency response is flat. Counterclockwise rotation reduces high end

response and increases low frequencies. Counterclockwise rotation decreases low end and increases

the high frequency response.

Stand-by Switch: Should be in the "down" or "stand-by" position when you apply power to the unit.

After turning the A/C mains on, place the switch in the "up" position to use the amplifier. You may leave

the unit "powered up" and place this switch in the "stand-by" position to mute the output. Do not leave

the amp in standby for more than 30 minutes at a time.

Power Indicator Lamp: The replacement light bulb is a 6.3v A/C.

NOTE: All switches are ON in the "up" position