Advanced Mxp-537 Посібник - Сторінка 4

Переглянути онлайн або завантажити pdf Посібник для Системи вводу/виводу Advanced Mxp-537. Advanced Mxp-537 12 сторінок. Peripheral input card

1 Introduction

The Mxp-537 Peripheral Input Card, on-board I/O module, is an internal peripheral for use with the Mx-5000

range of fire alarm control panels

Each card provides monitoring of up to 10, volt free, Switch inputs that can be individually configured to operate

in monitored or unmonitored mode

Cards are protocol Independent.

Up to 16 cards may be connected to a panel, allowing for up to 160 extra volt free inputs per panel.

Easily configured with the PC Configuration Tool

2 General Installation & Operation

The Mxp-537 Peripheral Input card offers 10 individually configurable, volt free, input monitoring circuits, as well

as including an Earth Monitor circuit in the event that the card is mounted remotely to its parent Fire Panel.

With up to 16 supported cards, this allows an extra 160 monitored inputs to be operated from a single Fire

Panel.

The Mxp-537 Peripheral Input card makes use of Software Monitoring And Real Time Power Management

techniques. This allows the card to minimise energy requirements without compromising input monitoring

capabilities.

Switch Input 10 has a dual operation mode. Its default behaviour is to act as a PSU fault monitor but this can be

overridden at the hardware level (via the on board DIP switches) to allow it to be configured as a

monitored/unmonitored input (configured via the PC Configuration Tool).

If monitoring of very fast input pulses is required (< 0.5s) the Mxp-537 can be coupled with the Mxp-053, Latch-

Stretch Input Module, for a fast and reliable solution that can detect input pulses down to 200ms.