Follett Maestro Chewblet 400 Series Посібник з монтажу та обслуговування - Сторінка 13

Переглянути онлайн або завантажити pdf Посібник з монтажу та обслуговування для Льодогенератор Follett Maestro Chewblet 400 Series. Follett Maestro Chewblet 400 Series 20 сторінок. Ice machine and top kit
Також для Follett Maestro Chewblet 400 Series: Посібник з монтажу та обслуговування (20 сторінок), Посібник з монтажу, експлуатації та обслуговування (20 сторінок)

23. Connect the ice transport tube(s) to the dispenser:

a) Drill 3/16" (5mm) holes through both sides of the tube

1/2" (13mm) from the tube end.

b) Collapse tube and insert through gasketed hole (Fig. 7).

c) Match tube holes to bracket tabs.

24. Route bin thermostat capillary tube from the 4" x 4"

(102mm x 102mm) junction box into bin alongside the ice

transport tube. Secure capillary tube into bracket (Fig. 7).

25. Reinstall the dispenser cover with supplied screws (Fig. 13).

26. Install telescoping chase (RIDE model ice machines only).

a) Mount lower chase section to chase bracket on counter

with supplied screws (Fig. 14.1).

b) Position upper chase section over lower chase section.

Align top of upper section to top of stainless dispenser top

(Fig. 14.2).

c) Drill pilot holes on both sides of chase and secure with

supplied screws (Fig. 14.3).

27. Turn ice machine power and water on.

28. After ice machine has made ice for approximately 15 minutes

complete the following start-up checks:

a) Dispense ice.

b) Hold ice on bin thermostat and make sure

ice machine shuts off.

c) Remove ice from bin thermostat and make sure

ice machine restarts.

Note: Ice machine has a 20 minute restart delay.

Fig. 13

Fig. 14