AmpliVox S230A Посібник користувача - Сторінка 6

Переглянути онлайн або завантажити pdf Посібник користувача для Спікери AmpliVox S230A. AmpliVox S230A 8 сторінок. Voice carrier portable public address system
Також для AmpliVox S230A: Посібник користувача (2 сторінок)

Друкувати сторінку
SPEAKER SET-UP
S1690T Microphone
Channel Selector
To Operate Model S230A with Dynamic Microphone
Make sure that both speakers are plugged into the "LEFT / RIGHT SPEAKER" jacks . Plug microphone into the "DYNAMIC" jack.
Turn amplifier on. Turn microphone on and talk into microphone. Rotate "VOLUME" control knob to obtain desired loudness level.
SW230A WIRELESS MICROPHONE SET-UP
I
W
M
NTERNAL
IRLESS
Select channel (1-16) on panel (A). Channel number must match channel number on wireless microphone transmitter (S1690T).
Use supplied screwdriver to select channel number.
W
M
IRELESS
ICROPHONE
Belt clip on the back of the unit clips the transmitter onto a belt or the transmitter simply can be put into a pocket. Plug the lapel / head-
set microphone into the Mic Input Jack (C). The lapel microphone can be clipped to a necktie or other clothing, using the supplied
clip. The lapel mic should be placed under the chin, as close to the center of the body as possible.
Rotate the Channel Selector Switch (B) on the wireless microphone transmitter to the same channel selected on receiver (
Slide the power ON/OFF switch
number as the wireless receiver, the LED light on the side panel
To Operate Model SW230A with Wireless Microphone
Insure that both speakers are plugged into the "LEFT / RIGHT SPEAKER" jacks . Turn amplifier "ON". The wireless receiver has a
separate "ON-OFF" switch and is located just below main power switch of amplifier. Slide to "ON" position. Insure both transmitter
and receiver are on the same frequency channel. On the S1690T wireless transmitter, move the power switch to "ON". RF LED on
side of amplifier will light, meaning that it is receiving signal. If RF LED does not light, check channel numbers. Speak into Lapel /
Headset microphone and rotate "VOLUME" control knob to obtain desired loudness level.
6
B
Model SW230A
Transmitter
Top Panel
B
C
D
R
ICROPHONE
ECEIVER
T
(S1690T) :
RANSMITTER
(D)
to the ON position (the LED indicator light will illuminate green). If you are on the same channel
A
Speaker Connection (as shown above)
Do for both set of speakers. Take a 40 Ft. speaker cable and
plug one end into the S1401 Speaker and the other end into
the "LEFT / Right" speaker jack on front panel.
Dynamic Microphone (as shown above)
Plug 1/4" plug end of microphone cable into the
"DYNAMIC" jack on front panel of amplifier.
(
ON SIDE OF AMPLIFIER
(A) of the amplifier will light when amplifier is turned "ON".
)
:
A
).