AmpliVox S500-WT Інструкції з налаштування - Сторінка 2

Переглянути онлайн або завантажити pdf Інструкції з налаштування для Спікери AmpliVox S500-WT. AmpliVox S500-WT 2 сторінки. Amplivox sound column lectern public address system

Друкувати сторінку

AUX OUT

Connection for 12 to 15V DC accessory

VOLUME

Rotate clockwise to increase amplification.

MICROPHONE INPUTS

There are three microphone inputs, which can be used simultaneously:

DYNAMIC

CONDENSER

WIRELESS

LINE IN L+R (SEPARATE-COMBINED)

Combines the separate left and right AUX LINE IN channels. This combined signal will be

amplified and appear on both the LEFT and RIGHT channels of the SPEAKER and LINE

OUT OUTPUTS.

AUXILIARY

If you desire to add pre-recorded music or sound effects during your presentation, just plug your CD

player, tape player or computer sound card into the

VOLUME

TONE

and

If using an external wireless receiver, for best sound quality it should be connected to the

level.

LINE IN jack.

OUTPUT

If you desire to tape record your speech or program, (using cable with standard phono plug)

connect the LINE OUT on the amplifier to the input on the tape recorder.

SPEAKERS

Two separately amplified speaker jacks (4-8 ohms).

PROBLEM SOLVING

HOWLBACK is the howl or screech often heard in sound reinforcement systems. It is caused

by sound from the loudspeaker returning to the microphone. AmpliVox systems utilize proven

acoustical principles to minimize this; however, there is no way to completely eliminate

howlback under conditions of high amplification. If howlback occurs check the following:

1. User covering the head of the microphone. Hold microphone under head slots.

2. Sound can easily re-enter microphone. Keep loudspeaker turned toward audience. Note:

sound can be reflected from hard surface back through the microphone. [Turn speaker]

3. User holding microphone in a reflecting position. [Turn microphone]

4. Volume setting too high. [Reduce microphone channel volume; compensate by speaking

louder or closer to the microphone.]

NO SOUND

Make sure amplifier POWER switch is turned on and red LED is lit. If switch is on and LED is

not lit, check to see that batteries are properly connected and at full charge. If using optional

power adapter, check to see that front panel connector is properly seated, and verify that power

source is live.

IF YOU HAVE ANY QUESTIONS OR PROBLEMS PLEASE CALL OUR CUSTOMER

SERVICE DEPARTMENT AT 1-800-267-5486.

- for standard dynamic cartridge microphones

- for electret or condenser microphones, which require phantom power

(supplied from the amplifier)

- accepts line-level output from wireless microphone receiver

control knobs, so that you may adjust the volume and tone to the appropriate

LINE IN

jack. The

also has its own