Follett UD300 Series Посібник з монтажу - Сторінка 10
Переглянути онлайн або завантажити pdf Посібник з монтажу для Льодогенератор Follett UD300 Series. Follett UD300 Series 12 сторінок. U300/ud300 series ice and beverage dispensers
Також для Follett UD300 Series: Посібник з експлуатації (17 сторінок)
Друкувати сторінкуInstalling remote icemaker(s)
Correct installation of remote icemaker(s) is critical to proper performance of
icemaker and dispenser. Refer to installation manual packed with icemaker for
!
important details on ice transport tube run, ventilation requirements for air-cooled
remote icemakers and other installation requirements. Failure to comply with
instructions will void warranty.
1. Position icemaker in desired location.
2. If ice transport tube will enter on tower side of dispenser, go to Step 5.
3. If ice transport tube will enter on side opposite tower, slide free end of ice transport tube(s) (without locator)
from inside of bin out through any of four prepared entry holes provided in dispenser sides, as shown.
4 Mate ice tube locator with appropriate slot in ice tube bracket and secure with two (2) thumbscrews provided.
5. Proceed with ice transport tube installation from dispenser to icemaker(s) in compliance with instructions
contained in Icemaker Installation Manual packed with icemaker.
Front view
Ice tube locator
(automatic load models only)
dispense
chute
Tower
side
ice tube
entry
auger
tube
1"
25 mm
ice tube bracket
drive shaft
Side view
Ice tube bracket
locator tabs
inserted in
ice tube
holes
9
ice tube
entry