AmpliVox SW225 Посібник користувача - Сторінка 3
Переглянути онлайн або завантажити pdf Посібник користувача для Акустична система AmpliVox SW225. AmpliVox SW225 6 сторінок. Voice projector powered speaker with internal 16 channel uhf wireless receiver and amplifier
Друкувати сторінкуBATTERY INSTALLATION / SET-UP
DO NOT MIX BATTERY TYPES OR
ATTEMPT TO RECHARGE ALKA-
LINE BATTERIES. EQUIPMENT
DAMAGE, SAFETY HAZARD OR
FIRE COULD RESULT.
R
EMOVE BATTERIES IF THE UNIT IS NOT GOING TO
BE USED FOR LONG PERIODS OF TIME TO PREVENT
.
LEAKAGE
SW225 Wireless Voice Projector: Unit runs on
AC power or battery power. The battery carriage
holds 10 D-cell alkaline batteries (not included) or
Amplivox optional S1465 NiCad Battery Pack
(Fig.4) (requires S1460 AC adapter to recharge.
Fig. 4). Or run on a 12 Volt DC adapter (automotive
cigarette lighter plug-in, not
Loosen four thumbscrews (Fig 2) and remove bat-
tery door from back of speaker. Remove battery
carriage (Fig 3). Insert 10 D-cell alkaline batteries,
observing polarity, or replace with the S1465 NiCad
battery pack. Carefully replace the battery carriage.
Reposition battery door and fasten the thumb-
screws.
Note: The battery holder cable comes from the
factory already plugged into the connector. If it
comes loose, push it in securely. (Turn the plug
over if it doesn't fit; it only fits one way.)
If using the S-1465 NiCad Battery pack (Fig 3),
Plug AC Adapter/ Recharger power supply (S1460)
into the "DC IN" jack on front panel of the amp.
Plug into a working electrical outlet. Charge 24
hours for full charge before using.
Wireless Transmitter
The transmitter bodypacks is operated by 1 - "AA"
alkaline battery. Before use, install battery as
shown (Fig. 5). Make certain the battery is fully
seated in its compartment so the cover slides in
place easily. Battery life with alkaline batteries is
approximately 8 hours of operating time.
When LED on top panel turns to RED the battery
should be replaced immediately.
included).
Fig 1
Fig 2
Fig 3
Fig 4
S-1465
Fig 5
S-1460
3