Comcater COMENDA Hi-Line HC14 Series Інструкція з експлуатації та технічного обслуговування - Сторінка 17
Переглянути онлайн або завантажити pdf Інструкція з експлуатації та технічного обслуговування для Посудомийна машина Comcater COMENDA Hi-Line HC14 Series. Comcater COMENDA Hi-Line HC14 Series 19 сторінок.
ENGLISH
FAULT
The machine does not switch on.
Water does not fill
Insufficient washing.
Insufficient rinsing
28
TROUBLESHOOTING
CAUSE
Main switch disconnected.
Water valve closed.
Drain hose filter dirty.
Rinse nozzles clogged.
ALARM H2:
Water missing in tank
WARNING F1:
Door open
Wash nozzles clogged.
Wash filter dirty.
Wash spray arm blocked
Detergent insufficient or missing
Wash conditions insufficient
ALARM H3:
Wash temperature insufficient
ALARM A3:
Probe disconnected or interrupted
Rinse nozzles clogged.
Limestone obstruction in boiler.
Water pressure below 2 bar. - 200 Kpa.
Insufficient temperature.
Improper position of nozzles or nozzles
damaged
ALLARME H1:
Rinse temperature insufficient
ALLARME A3:
Probe disconnected or interrupted
ALLARME A5:
Boiler does not heat
Part 2: Reserved for Operator
SOLUTION
Connect switch.
Open the valve.
Detach the drain hose (7 Fig.6) and clean the filter.
Unscrew and wash the nozzles (20 Fig. 8) in running water.
Check mains water supply;
Spegnere e riaccendere la macchina
Switch the machine off and back on check that the door
is closed perfectly and/or Level/check levelling of the
machine
Clean the nozzles of the wash spray arms (18 Fig. 8).
Clean the filters (13/14/15/16 Fig. 8).
Remove and clean the spray arm (17 Fig. 8)
Restore the detergent in the tank and check its concentra-
tion.
Check that the washing phase is carried out correctly.
Wait for the tank to reach running temperature and perform
a new cycle.
Contact the Assistance Service.
Unscrew and wash the nozzles (20 Fig. 8) in running water
Contact the Assistance Service.
Wait for pressure to be restored or purchase a new pres-
sure pump.
Contact the Assistance Service.
Check that the nozzles are in the correct position and
replace the damaged ones
Wait for the boiler to reach running temperature.
Contact the Assistance Service.
Contact the Assistance Service.
Check that the drain pipes are clean